RAMPS 1.4 PCB
Electronics kit for your 3d Printer. Thanks to the Taurino Power, it's possible to work with both 12V and 24V.
Description
The RAMPS 1.4 has the ability to function on 12V and on 24V.
We put 5 stepsticks in the combination package RAMPS 1.4 + Taurino Power Electronics so you can connect a dual extruder or to command 2 Z-axis motors seperately.
NOTE: No stepstick included. These can be ordered seperatly or you can buy the full kit with Taurino Power Electronics.
Content
1x RAMPS 1.4 PCB
Datasheet
Arduino 2560-R3 compatible (easy to change/flash firmware for end user)
ATmega16U2 (with enhanced firmware) for high speed USB serial connection (up to 2MBit)
Can be used with 12V-35V
(e.g. RAMPS board with 24V can supply voltage (via D1) to TAURINO for standalone operation
No damage of ATmega2560 possible due to to high power supply (e.g. from RAMPS or external connector)
Usage & Maintenance
Pay attention that your body is grounded to prevent damage from static electricity. This leads to irreversible damage of your electronic board.
See the linked blogpost to calibrate your stepsticks.